RIDOX Replica Garage : Reiter Engineering Lamborghini Gallardo LP 560-4 '08 GT3-R Base Model 554PP

Gallardo GT3-R Reiter Engineering replica 520HP 1190kg, easy 2:02s at Silverstone GP

  1. Ridox2JZGTE

    Notes:

    This Lamborghini Gallardo replica is based on Reiter Engineering Gallardo GT3-R that has been sold from 2006. Specs based on 2010 model year GT3-R with 520HP, 1190kg and 40/60 weight distribution.

    The weight distribution can't be replicated without getting the car overweight, so I decided to stick with stock weight distribution 44/56. Weight at 1190kg and power set at 520HP.

    Suspension is quite tricky on this car, I setup the front spring rate to be as responsive as possible to avoid understeer. The rear spring rate is optimized for balance, any higher or lower will alter the car handling behavior, so it's very much well tweaked so you can fine tune the car just by lowering or raising rear spring rate. More higher rear spring will cause oversteer, while lower will make the car harder to rotate.

    Damper has bee tweaked to support the stiff springs, giving good traction out of corner and able to brake very late without losing grip at the front. ARB set at same stiffness as it gives the best balance. This will give the Gallardo go kart like handling, direct, responsive and raw.

    LSD is 2 way, based on real life spec of 45% lock LSD, the front has been set at all 5 to give as close as possible to open diff. Torque has been set at 90% rear, sadly 100% is not possible to make RWD Gallardo GT3-R. Fear not, the car has been tuned to feel and drive like a RWD as much as possible.

    Gearing comes from homologated Gallardo GT3-R 6 speed sequential ratio with custom final to give balance of top speed and acceleration.

    I tuned and tested the Gallardo GT3-R at Tsukuba, Brands Hatch GP, Silverstone GP, Bathurst and Ascari.

    The car is capable of low 54s at Tsukuba and 2:02s at Silverstone GP during early build phase.

    Please leave feedback about the replica, I always consider this car as a work in progress

    ENJOY :cheers:


    Game Version:
    1.06
    Controller Type:
    Game Controller
    Vehicle Manufacturer:
    Lamborghini
    Performance Points:
    554 PP
    Max. Power:
    520 HP
    Weight:
    1190 kg
    Weight Distribution:
    44
    Max. Torque:
    409.8 ft-lb
    Drivetrain:
    4WD
    Tires (Front):
    Racing: Hard
    Tires (Rear):
    Racing: Hard
    Pit Service:
    • Improve Body Rigidity
    Wheel Model:
    OZ Racing Botticelli III
    Custom Parts (Other):
    NO OIL CHANGE
    Improve Body Rigidity ( INSTALLED in this build ) - MANDATORY- Gallardo GT3-R has chassis reinforcement and roll cage.
    Custom Rear Wing :
    Wing Mount Standard Type B
    Wing Large Type A
    Winglets Type A
    Height +0 and Width +40
    Wheels : Standard Size - OZ Racing Botticelli III, OZ Racing Superfogiata in GT Matte Dark Gray
    Car Paint : Black, Nero Noctis, Arancio Argos
    Suspension Kit:
    Height-Adjustable, Fully Customizable Suspension
    Transmission:
    Fully-Customizable Transmission
    Clutch:
    Twin-Plate Clutch Kit
    Exhaust:
    Racing Exhaust
    Weight Reduction:
    Stage 3
    Other Parts:
    • Racing Brake Kit
    • Carbon Fiber Driveshaft
    • Fully-Customizable Mechanical Limited-Slip Differential
    • Torque-Distributing Center Differential
    • Window Weight Reduction
    Ride Height (Front):
    75
    Ride Height (Rear):
    75
    Spring Rate (Front):
    14.02
    Spring Rate (Rear):
    16.72
    Dampers - Compression (Front):
    6
    Dampers - Compression (Rear):
    8
    Dampers - Extension (Front):
    6
    Dampers - Extension (Rear):
    8
    Anti-Roll Bars (Front):
    4
    Anti-Roll Bars (Rear):
    4
    Camber Angle (Front):
    0.2
    Camber Angle (Rear):
    0.2
    Toe Angle (Front):
    0.00
    Toe Angle (Rear):
    0.16
    Brake Balance (Front):
    5
    Brake Balance (Rear):
    4
    Max. Speed:
    300
    Max. Speed Unit:
    kph
    Transmission (1st Gear):
    2.560
    Transmission (2nd Gear):
    1.850
    Transmission (3rd Gear):
    1.420
    Transmission (4th Gear):
    1.140
    Transmission (5th Gear):
    0.940
    Transmission (6th Gear):
    0.810
    Transmission (Final Gear):
    4.700
    Transmission (Additional Comments & Instructions):
    Transmission - Sequential 6 Speed Homologated Ratio with Sachs Double Plate Clutch
    Install all power parts
    Set Default
    Set Final to 5.000
    Set Auto Max Speed at 300kmh / 186mph
    Adjust each gear :
    1st 2.560
    2nd 1,850
    3rd 1.420
    4th 1.140
    5th 0.940
    6th 0.810
    Set Final : 4.700
    Initial Torque (Front):
    5
    Initial Torque (Rear):
    27
    Acceleration Sensitivity (Front):
    5
    Acceleration Sensitivity (Rear):
    27
    Braking Sensitivity (Front):
    5
    Braking Sensitivity (Rear):
    27
    Front/Rear Torque Distribution:
    10
    Power Limiter:
    88.2%
    Downforce (Rear):
    20
    Ballast Weight:
    30 kg
    Ballast Position:
    30%
    ABS Level:
    0
    Traction Control:
    0
    GT6champNK_69 and BJahalt88 like this.

Recent Reviews

  1. ALB123
    ALB123
    5/5,
    A hardcore GT3 driving experience. The car is stiff, but capable. You can drive hard, deep into corners without fear of losing grip. Sadly, the AWD can't be removed but it almost feels like a RWD car (just with a little more front bite!) This car will give you a workout, but it will also give you low lap times once you learn how she likes to be driven.
    1. Ridox2JZGTE
      Author's Response
      Thanks ALB123 :)
  2. BEjamin
    BEjamin
    3/5,
    few tweeks & its fast ! 63 kg -50 47/53 weight & rear diff @ 15 20 15 . also my ride height is 95 95 .
    1. Ridox2JZGTE
      Author's Response
      Thanks for trying the tune and giving the rating :) Glad with a few tweaks the car suited to your needs and driving style, it's a replica but also a base tune :D