HELP CSR-E off center after few laps in GT5

  • Thread starter Thread starter VanWeeD
  • 9 comments
  • 1,849 views
V

VanWeeD

Messages
80
Taiwan
Taipei
Messages
CYPSY
Messages
VanWeed420
Hi, I have CSR-E w CSP set up for GT5, I find CSR-E is off center after few laps into GT5, this matter doesn't appear on Forza4.
When this occurs playing GT5, I have to reboot the wheel, so its back to center again, but this is very annoying to reboot the wheel, especially when race online.

I tried to re-flash the firmware, problem still there, any ideas how I can fix this matter?

CSR-E is currently running 721b firmware!
 
My CSR Elite is off center too, but only in the menu's in GT5.

When racing it's fine. Also tried to reflash the firmware, but it didn't solve it for me.

I'm not bothered by it now, because my replacement wheel is under way (for an other issue)
 
Aww, I might have to ditch my CSR-E for now when play GT5, n switch back to my beloved T500 .... but I sure will miss CSP.....
I really hope someone comes up with the adapter for T500 to use CSP in GT5:drool:
 
o btw, CSR-E is off-center to the left abt 5 degree or less in GT5 menu, in race it is straight, but after few laps its off-center 10 degree to the right .. any thoughts?
 
My GT2 had something similar when new (but it was in Forza not Gt5). After contact with support it turned out that the code wheel sensor was the issue. That was replaced and it has remained perfectly centred no matter how many laps I run ever since.
 
My symptoms were always quickest visible when I was running Forza with rewind, because if you rewind round a corner the wheel would spin through the full range a few times. So yes, turning the wheel rapidly lost center for me too.

I still think it's the codewheel sensor, but then I'm not Fanatec so my diagnosis is totally worthless :). Just email their support and use a good video or photos to show how off-center it gets.
 
WoW... Good News, after sending video to Fanatec Support, they have decided to send me another unit!! Thanks to Fanatec Supports's prompt reply! Awesome!!
 

Latest Posts

Back