I wanted to take my pedals apart to eliminate the clutch pedal and move the brake pedal to where the clutch is. I started this assuming the metal spacers in the pedals were all the same... Much to my dissapointment, they are almost all different sizes so putting it back together is proving to be rather annoying. I was going to make some custom spacers to be able to use the brake on the left but I decided to put them back in original orientation. Problem is I cannot get them to line up again.
I would have a favor to ask of anyone who owns these pedals. Using a tape measure or a metric caliper ideally, can you please measure for me the sequence of spacers?
Looking at the pedals as your feet would go on them, gas pedal on the right, brake in middle and clutch on left. On the bar closest to the player, Starting from the right of the gas pedal going left, tell me what size the spacers are.
Then the same thing on the bar farthest from the player, same order, right of gas pedal going left.
I thank you very much in advance, my pedals lay in pieces until someone is able to help or I get very bored and start playing with math (which I hate)
I would have a favor to ask of anyone who owns these pedals. Using a tape measure or a metric caliper ideally, can you please measure for me the sequence of spacers?
Looking at the pedals as your feet would go on them, gas pedal on the right, brake in middle and clutch on left. On the bar closest to the player, Starting from the right of the gas pedal going left, tell me what size the spacers are.
Then the same thing on the bar farthest from the player, same order, right of gas pedal going left.
I thank you very much in advance, my pedals lay in pieces until someone is able to help or I get very bored and start playing with math (which I hate)
. If you move this to the