brake and clutch inversed on THRUSTMASTER T3PA-GT

[caiez]

Hello,

I have a problem with a crankset THRUSTMASTER T3PA-GT bought secondhand. The brake and clutch pedal is inversed. I read more post on forum but i don't found solution.

Pleaze if you have an idea for me ?

Thanks (ans sorry for my english :-))

 

[WildRun]

Hi Caiez, you probably means the Accelerator & the Clutch? Just make sure that the led of your base is RED. If GREEN then press (and release) the MODE button (located on the wheel base) during 2 seconds (this will invert the Accelerator & the Clutch signals).

 

[caiez]

hi and thanks for your asnwer. I test your solution and :

Red mode :

If i press left pedal : no affected
if i press middle pedal : it's left pedal is affected
if i press right pedal : it's ok, it's right pedal
​

Greend mode :

If i press left pedal : no affected
if i press middle pedal : it's right pedal is affected
if i press right pedal :it's left pedal is affected
​

I would like :

If i press left pedal : no affected
if i press middle pedal : it's middle pedal is affected
if i press right pedal :it's right pedal is affected
​

Thanks (ans sorry again for my english :-))


Edit+ QuoteReply

​

 

[FPV MIC]

hi and thanks for your asnwer. I test your solution and :

Red mode :

If i press left pedal : no affected
if i press middle pedal : it's left pedal is affected
if i press right pedal : it's ok, it's right pedal
​

Greend mode :

If i press left pedal : no affected
if i press middle pedal : it's right pedal is affected
if i press right pedal :it's left pedal is affected
​

I would like :

If i press left pedal : no affected
if i press middle pedal : it's middle pedal is affected
if i press right pedal :it's right pedal is affected
​

Thanks (ans sorry again for my english :-))


Edit+ QuoteReply

​

It could possibly be that the person that previously owned the pedals had a sim rig with a centre pole support for the wheel base. Some people who left foot brake swap the clutch and brake pedals over so it's much more comfortable for them and the centre pole doesn't get in their way when they brake. I'd suggest taking the cover off and seeing if you can see if any wires look like they've been extended. If they have then it's simply a matter of swapping them back to their proper positions.

 

[caiez]

it's my fear, i look this tomorrow, ty

 

[FPV MIC]

it's my fear, i look this tomorrow, ty

This is how it should look inside.

And just be very careful taking the base off because there's a plug that has to be disconnected to remove the base. You can see it in the video below. It also shows the basic removal process.

 

[caiez]

ok i test now, i change wires and i think it's ok but ... no.

If i change the wires of the brake and the cluthe, the result is the same.
I think the problem is on the programm no ? it's possible to change this on programm ?

I am desperate ...

 

[caiez]

ok sorry, my pedal it's ok, but the brake does not work on the control panel. I am sur the connection is good. I don't understand.