Drivehub GT7 - CSL Elite V2 Brake Load Cell too sensitive

3
United Kingdom
United Kingdom
I have an issue with the load cell brake on CSL ELITE V2 pedals.
I am running GT7 on the PS4 with drivehub in fanatec mode. The load cell brake pedal on fanatec CSL elite V2 pedals is very sensitive even with breaking force set to max. Not much pressure is required to hit 100% braking force. In fanalogic mode the brake behaves how it should but then there is the oscillation problem with the wheel.
i am running the latest stable 2.1.1 stable firmware and my pedal set is connected into the CSL base.
Does anyone know if there any way to make the brake operate in fanatec mode like it does in fanalogic mode ?
Apart form that, Drivehub is a fantastic product. Loving it.
 
My bad it was my fault note to self RTFM!

i already had the base powered on when connecting Drivehub to PS4, Doh!

Correct procedure

Connect PS4 controller to Drivehub
Connect wheelbase to Drivehub
Connect Drivehub to PS4
Power on PS4 (wait till logon screen)
Power on CSL DD Base (must be in PC mode - red light)

CSL DD will calibrate and you will see Drivehub recognise the wheelbase as CSL DD

Now the load cell brake on my CSL Elite pedals function as intended.
 
My bad it was my fault note to self RTFM!

i already had the base powered on when connecting Drivehub to PS4, Doh!

Correct procedure

Connect PS4 controller to Drivehub
Connect wheelbase to Drivehub
Connect Drivehub to PS4
Power on PS4 (wait till logon screen)
Power on CSL DD Base (must be in PC mode - red light)

CSL DD will calibrate and you will see Drivehub recognise the wheelbase as CSL DD

Now the load cell brake on my CSL Elite pedals function as intended
 
Back