- 4,817
- Bulgaria
You will need one bracket Hydro Tech 42-46(diameter in millimeters) and one nut for M6 bolt which you will put on the original bolt(this is very important or the bolt will penetrate too deeply into the shaft of the wheel base)
You will also need to drill a 6mm hole in the middle of the bracket for the bolt.
You can tighten the bolts hard, nothing will break and check from time to time whether the bolts have not loosened.
You will also need to drill a 6mm hole in the middle of the bracket for the bolt.
You can tighten the bolts hard, nothing will break and check from time to time whether the bolts have not loosened.
Last edited: