- 1
- United Kingdom
- Hussain57
Ive seen too many people complaining about this online so I thought id post a possible solution. If your g27 is not calibrating properly e.g. On an angle, this is a possible remedy. I've fixed my one. You have to take apart the wheel. About 6 screws on the back of the wheel where all the wires go. However, once you've done that the back still won't come apart. You then have to open up the wheel, then, take off a further two screws. THEN, the back will come apart. There are about 4 separate plastic pieces housing around 4 wires each. It is the bottom left ( I think).it's simply popping everything back in. I know a website that has step-by-step instructions. Don't have the link but type in "Lenkrad JL- G25". Hope this helps. Re-post here how it went. Good luck.
