GT6 Fanatec pedals not working help please PS3

  • Thread starter Thread starter werks17
  • 7 comments
  • 5,618 views
W

werks17

Messages
3
United States
United States
Messages
werks08
I have a fanatec GT3rs v2 wheel, csr seat and csr pedals and my pedals don't work on gt6 ps3. When the gas is pressed brake lamps flash and go out and the engine will blip the throttle. The brake pedal does not work. If you hold brake and gas down together once you stop it will rev the engine when you let off the brake the engine just returns to idle with no movement of the car. Has anyone have this set up running or any other hints that may make it work,everything is new. The only other game I have tried it on is GRID2 demo and it had the same problem Thanks for any help. I have also emailed Fanatec, awaiting response.
 
Yes, Also just installed driver on pc and found pedals not working. updated firmware in wheel, no change. once I was able to get them to calibrate. That was before firmware update and after the one time it did connect it would not with the old firmware. Just guess I probably have a faulty set of pedals Will update if anything changes thanks
 
@werks17 Sounds like a split solder on the throttle sensor. I had the same thing a while back, same symptoms. Get on to Fanatec and describe the issue and they should send you a new sensor, which takes seconds to fit.
 
I have the Porsche GT2 wheel and use both the Club sport pedals and Logitech G27 ones (obviously at different times). The G27 do this all the time and sometimes so does the CS.

What I do to fix it is once you are in the game and ready to race unplug the pedal wire where it goes into the wheel and re-plug it back in. Sometimes I have to do this 4 or 5 times but usually it works fine on the 3rd go. It must reset/recalibrate the pedals.

Once it recalibrates it is fine until you shut down again. Just a glitch, that's all ;-)

I hope this helps.
 
TT92
I have the Porsche GT2 wheel and use both the Club sport pedals and Logitech G27 ones (obviously at different times). The G27 do this all the time and sometimes so does the CS.

What I do to fix it is once you are in the game and ready to race unplug the pedal wire where it goes into the wheel and re-plug it back in. Sometimes I have to do this 4 or 5 times but usually it works fine on the 3rd go. It must reset/recalibrate the pedals.

Once it recalibrates it is fine until you shut down again. Just a glitch, that's all ;-)

I hope this helps.
Click to expand...
That's a common problem when using Logitech pedals with a Fanatec wheel. My G25 pedals never worked right with my old GT3 RS, which is why I bought Clubsports. The problem is not related to the one outlined in the OP.
 
problem resolved found clutch was the only input that did not have any response. So I cleaned poteinometer with contact cleaner problem solved all pedals work as they should Thanks for the help
 

Latest Posts

Back