Help my g920 has started to massivly over turn on calibraton when it starts.

  • Thread starter Soulee
  • 1 comments
  • 546 views
2
New Zealand
New Zealand
My g920 at start up now over turns left and right so bad.
It doesnt do the normal.2-3 turns to right and left and center itself.
It now goes around left and right over 10 times then dosnt center. It will center where ever.
This is twisting the cable that goes to wheel buttons so bad that it pulls the connection out of the wheel button board.
I have had to pull it to pieces just to untwist the cable, and it is twisted so tight.
Is there something i missed, as calibration is still doiing so many turns and centers anywhere, and again twist cable.
I put it back together only for it.to do it again.
All the motors are working, and buttons when put back together, only for it to do it again.
16635434485214255148657329257204.jpg
Any help would be.welcome.
As in a tear down and rebuild so i make sure its correct.
 
Whatever was there stopping the wheel from turning to much is broken. You can feel it when you turn your wheel too much. Did you get mad and break them? Just look for broken plastic or a diagram of a working wheel and see whats missing.
 
Back