How to remove/install CSP Load Cell

  • Thread starter zqxwjv
  • 4 comments
  • 3,034 views
Z

zqxwjv

221
zqxvjw
Hello,

I expect to receive my replacement load cell today. I don't know if it will come with remove/install instructions. Does anyone happen to know if there is a tutorial/video on how to replace the CSP brake load cell? (or instructions with photos)

Thanks,

Zqxwjv
 
1. Remove pedal assembly from your stand.
2. Turn it upside down and loosen but don't remove the small metric allen head set screw on the left of the load cell.
3. Carefully remove the three wire electrical connector from the PC board noting that the white wire is at the top.
4. Slide the old load cell out of the black metal block noting its position in that block.
5. Slide the new one in place with the help of screwdriver pushing the metal bar back into the black metal block.
6. Check that the metal push bar inside the block aligns with the center of the "dimple" on the load cell.
7. Snug up the loosened set screw when the load cell is aligned.
8. Reconnect the three pin electrical connector with the white wire on top using a pair of tweezers to set it in place.
9. Reinstall the assembly in your stand.
 
You can use the tutorial on the fanatec website for deconstruction of the csp's, not really necessary for th loadcell but nice to now where you should be carefull
Then go for the post above, i'm also receiving a loadcell tomorrow and have already prepared the csp's for replacement, it.s real easy :)
 

Latest Posts

Back