- 559
- Zero7159
I neglected to post this in January, but I thought at least some folks might be interested in how I ultimately set up my racing wheel, pedals and stand. The only change is that I now am using a Sony 32" HDTV, rather than the Vizio that is depicted in the pictures below
First, here is what I started with before I received the GT2 and Clubsport pedals. It is my Driving Force GT wheel and pedals mounted on the wheelstandpro:
By zero7159 at 2011-01-31
1. I first cut a piece of particle board:
By zero7159 at 2011-01-31
2. After painting the particle board, I used the Xbox pedal adapter to mount it to the wheelstandpro:
By zero7159 at 2011-01-31
3. This shows the bottom of the mount, with the screw in the middle:
By zero7159 at 2011-01-31
4. I then attached the Clubsport pedals to the mounted particle board. There are screw holes in the feet of the pedals.
By zero7159 at 2011-01-31
5. Here is how I attached the GT2 wheel to the top plate of the wheelstandpro. Two screws and the table clamp did the trick:
By zero7159 at 2011-01-31
6. Here is the completed set up:
By zero7159 at 2011-01-31
Let me know what you think.
First, here is what I started with before I received the GT2 and Clubsport pedals. It is my Driving Force GT wheel and pedals mounted on the wheelstandpro:
By zero7159 at 2011-01-31
1. I first cut a piece of particle board:
By zero7159 at 2011-01-31
2. After painting the particle board, I used the Xbox pedal adapter to mount it to the wheelstandpro:
By zero7159 at 2011-01-31
3. This shows the bottom of the mount, with the screw in the middle:
By zero7159 at 2011-01-31
4. I then attached the Clubsport pedals to the mounted particle board. There are screw holes in the feet of the pedals.
By zero7159 at 2011-01-31
5. Here is how I attached the GT2 wheel to the top plate of the wheelstandpro. Two screws and the table clamp did the trick:
By zero7159 at 2011-01-31
6. Here is the completed set up:
By zero7159 at 2011-01-31
Let me know what you think.
