S10 Amuse SetUp on Standard

  • Thread starter GT5Pro
  • 4 comments
  • 4,865 views
GT5Pro

GT5Pro

471
skaterguymoose
Power is set to (-1)
Weight is set to (109)
Aero is set to (20) front and rear
Ride Height is (-2) f&r
Spring Rate is f(7) r(5)
Damper is (7) f&r
Toe is f(-0.10) r(0.00)
Camber is f(2.2) r(1.7)
Brake Balance is (5) f&r
Max turning angel is (50)
TC is (OFF)
ABS is (1)
1st: (2.697)
2nd: (1.819)
3rd: (1.367)
4th: (1.098)
5th: (0.913)
6th: (0.785)
7th: (0.637)
FDR: (4.716)


I use this setup regularly with 1st being obtainable early to mid 5th lap, the weight represents a 220 lb driver
 
OK gave it a run. Took the lead in the chicane on lap 2. Total race time 9:52.6xx Best lap 1:55.8xx

I kept hitting the rev limiter in 3rd in the esses so I just used 4th. It felt like it bogged a little in 4th but it was better than bouncing against the rev limiter. This gearing is fine for drivers who are just trying to pass S10 because they will carry less speed through the esses.

I also felt it had a bit of a mid-corner push. And a bit much lift-off oversteer. I'm going to replace the negative front toe with positive to see if that fixes the mid-corner push, put in some positive rear toe to reduce lift-off oversteer, tweak 3rd gear a little and give it another go.


Edit: With those tweaks the car feels very balanced (to me). Took the lead in 200R on lap 2. TRT 9.48.4xx Best lap 1:55.2xx.
 
Last edited:
Yeah it is kinda a generic tune, I've been noticing a lot that people are having difficulty with s10 and this tune consistently places first so I threw it out there
 
i don't know what it is about this track. i tried this setup and developed my own. i can't turn anything less than a 2:03.

----

had physics on pro, switched to std, took 3rd after a few tries.
 
Last edited:

Latest Posts

Back