Standing burnouts..

  • Thread starter Thread starter GTO_VR4
  • 8 comments
  • 840 views
Messages
1,107
United States
Earth
If you ever been to a drag strip, you know what I mean by standing burnouts

its when you have a high powered FR car and hold your brake and do the ultimate burnout..

until recently, i never knew u could do this in GT2..

all you gotta do is purchase a brake controller and set the power of the brake on the front the highest it could go..Super soft in front and sim in back are pretty easy to start of with..

on the start of the test run, rev your engine and just b4 it red lines, hold brake and gas...if you look at your gear# and if its high lighted, that means your losing grip and doin a standin burnout..

I just wish there was smoke commin out the tires.. :cry:
 
Originally posted by FuJi K
i can perform these....

First of all...
Must have Simulation tires, super soft tires, brake bal. controller, high HP.

Lower your Brake effect at the rear to it's lowest.
Raise the front brake effect to it's highest.
Set supersoft tires to the front.
Set simulation tires to the rears.
Go to a stage somewhere (race, Machine Test etc.)

Apply Brake and Gas
Let go of Brake and watch for your 1st GEAR to light up then press and hold brake again. IF you let the car roll to about 10mph or above this speed, you won't be doing a standing still burnout.

NOTE: To know that you're doing a burnout, you're standing still with the car revving and your 1st gear light up. (What i mean by light up is when the gear number lights up under the RPM tech.)

Try it out.
 
ive done this before accidently, but since there was no smoke (i really wish there was) i didnt find it as cool as say stayin head on with a wall and applyin gas and u see smoke...well...not really smoke, but still more of a burnout....minus the whole wall part
 
How do u get mad smoke out of the tires? I've seen a screenshot somewhere on the internet of a GT-One race doing a burnout with moutains of smoke behind it. Tell me how if you know.
 
Back