T500 PCB

  • Thread starter MrF1
  • 6 comments
  • 1,177 views
MrF1

MrF1

196
Australia
Australia
Hi all
Will try to keep this short.

Hardware: T500RS, PS4


I Made a handbrake with micro switch

Pulled t500 base off and soldered onto L3 and R3 (with pcb removed)

Re fitted everything and now i have no power to the wheel base. Nothing. Nada


Im fairly new to electronocs but im no mug. Everything has been done with extreme care and patience.

I bought a multimeter and ive checked what i can. Theres 24V to the wheel at power point and 24 to the main PCB. Thats as far as i can get.

Any ideas, solutions, input....

20170623_153915.jpg
20170623_162227.jpg
 
Any close ups of the PCB board?

Need both sides since the board will be double sided.

Do it with no flash to avoid glare.

use macro lens or mode.
 
It would've been nicer to see it uninstalled.

Also by both sides I mean top and bottom(Think Side A and side B) of a cassette tape)
 
Grayfox
It would've been nicer to see it uninstalled.

Also by both sides I mean top and bottom(Think Side A and side B) of a cassette tape)
Click to expand...

Thanks mate
I will pull that out today.

Uninstalled looks the same minus 3 wires
 
FIXED

the input plug was playing funny buggers.

Its now hard wired. I never picked it because testing the 4 pin plug to the wheel showed power. Problem was the pins were not pushing into the female properly.
I dont know why it decided to do that now but just removing it for my mod was enough for thr male pins to pack in.

Thanks for your help anyway :)
 

Latest Posts

Back