Thrustmaster T-LCM pedals not powering up

  • Thread starter Thread starter LegoLazurus
  • 12 comments
  • 8,340 views
L

LegoLazurus

Messages
12
Canada
Canada
Hey Folks,

When I plug my Thrustmaster T-LCM pedals into my PC everything works fine including the calibration tool. When I connect the pedals to my t300rs through the RJ12 cable the pedals will not power up has anybody ever experienced this issue?
 
LegoLazurus
Hey Folks,

When I plug my Thrustmaster T-LCM pedals into my PC everything works fine including the calibration tool. When I connect the pedals to my t300rs through the RJ12 cable the pedals will not power up has anybody ever experienced this issue?
Click to expand...
Have you updated the base firmware to the latest version? It's v34.
 
Ok. When you turn on the wheel, the blue led behind the pedal plate lights up? The mode light on the base flashes 8 times?
 
The blue light only turns on when connected to my PC, not when it is attached to the base.
 
Last edited:
Yes you can reinstall the firmware, both normally or bootloading it (the procedure is on the TM support website).

At this point I guess it can be the cable itself to be faulty. Did the tclm ever worked or its brand new?
 
Fox Andersson
Yes you can reinstall the firmware, both normally or bootloading it (the procedure is on the TM support website).

At this point I guess it can be the cable itself to be faulty. Did the tclm ever worked or its brand new?
Click to expand...
Thanks Sir.
 
You have Disconnect the USB Cable to PC if you connected to your Wheelbase?
 
I found the problem. Thanks everyone for your help.

There is a hairline slice on the RJ12 cable. 😞
 
Back