RIDOX Replica Garage : Reiter Engineering Lamborghini Gallardo LP 560-4 '08 GT3-R Base Model 554PP

RIDOX Replica Garage : Reiter Engineering Lamborghini Gallardo LP 560-4 '08 GT3-R Base Model 554PP


Notes:

This Lamborghini Gallardo replica is based on Reiter Engineering Gallardo GT3-R that has been sold from 2006. Specs based on 2010 model year GT3-R with 520HP, 1190kg and 40/60 weight distribution.

The weight distribution can't be replicated without getting the car overweight, so I decided to stick with stock weight distribution 44/56. Weight at 1190kg and power set at 520HP.

Suspension is quite tricky on this car, I setup the front spring rate to be as responsive as possible to avoid understeer. The rear spring rate is optimized for balance, any higher or lower will alter the car handling behavior, so it's very much well tweaked so you can fine tune the car just by lowering or raising rear spring rate. More higher rear spring will cause oversteer, while lower will make the car harder to rotate.

Damper has bee tweaked to support the stiff springs, giving good traction out of corner and able to brake very late without losing grip at the front. ARB set at same stiffness as it gives the best balance. This will give the Gallardo go kart like handling, direct, responsive and raw.

LSD is 2 way, based on real life spec of 45% lock LSD, the front has been set at all 5 to give as close as possible to open diff. Torque has been set at 90% rear, sadly 100% is not possible to make RWD Gallardo GT3-R. Fear not, the car has been tuned to feel and drive like a RWD as much as possible.

Gearing comes from homologated Gallardo GT3-R 6 speed sequential ratio with custom final to give balance of top speed and acceleration.

I tuned and tested the Gallardo GT3-R at Tsukuba, Brands Hatch GP, Silverstone GP, Bathurst and Ascari.

The car is capable of low 54s at Tsukuba and 2:02s at Silverstone GP during early build phase.

Please leave feedback about the replica, I always consider this car as a work in progress

ENJOY :cheers:


Game Version
1.06
Controller Type
Game Controller
Vehicle Manufacturer
Lamborghini
Performance Points
554 PP
Max. Power
520 HP
Weight
1190 kg
Weight Distribution
44
Max. Torque
409.8 ft-lb
Drivetrain
4WD
Tires (Front)
Racing: Hard
Tires (Rear)
Racing: Hard
Pit Service
  1. Improve Body Rigidity
Wheel Model
OZ Racing Botticelli III
Custom Parts (Other)
NO OIL CHANGE
Improve Body Rigidity ( INSTALLED in this build ) - MANDATORY- Gallardo GT3-R has chassis reinforcement and roll cage.
Custom Rear Wing :
Wing Mount Standard Type B
Wing Large Type A
Winglets Type A
Height +0 and Width +40
Wheels : Standard Size - OZ Racing Botticelli III, OZ Racing Superfogiata in GT Matte Dark Gray
Car Paint : Black, Nero Noctis, Arancio Argos
Suspension Kit
Height-Adjustable, Fully Customizable Suspension
Transmission
Fully-Customizable Transmission
Clutch
Twin-Plate Clutch Kit
Exhaust
Racing Exhaust
Weight Reduction
Stage 3
Other Parts
  1. Racing Brake Kit
  2. Carbon Fiber Driveshaft
  3. Fully-Customizable Mechanical Limited-Slip Differential
  4. Torque-Distributing Center Differential
  5. Window Weight Reduction
Ride Height (Front)
75
Ride Height (Rear)
75
Spring Rate (Front)
14.02
Spring Rate (Rear)
16.72
Dampers - Compression (Front)
6
Dampers - Compression (Rear)
8
Dampers - Extension (Front)
6
Dampers - Extension (Rear)
8
Anti-Roll Bars (Front)
4
Anti-Roll Bars (Rear)
4
Camber Angle (Front)
0.2
Camber Angle (Rear)
0.2
Toe Angle (Front)
0.00
Toe Angle (Rear)
0.16
Brake Balance (Front)
5
Brake Balance (Rear)
4
Max. Speed
300
Max. Speed Unit
kph
Transmission (1st Gear)
2.560
Transmission (2nd Gear)
1.850
Transmission (3rd Gear)
1.420
Transmission (4th Gear)
1.140
Transmission (5th Gear)
0.940
Transmission (6th Gear)
0.810
Transmission (Final Gear)
4.700
Transmission (Additional Comments & Instructions)
Transmission - Sequential 6 Speed Homologated Ratio with Sachs Double Plate Clutch
Install all power parts
Set Default
Set Final to 5.000
Set Auto Max Speed at 300kmh / 186mph
Adjust each gear :
1st 2.560
2nd 1,850
3rd 1.420
4th 1.140
5th 0.940
6th 0.810
Set Final : 4.700
Initial Torque (Front)
5
Initial Torque (Rear)
27
Acceleration Sensitivity (Front)
5
Acceleration Sensitivity (Rear)
27
Braking Sensitivity (Front)
5
Braking Sensitivity (Rear)
27
Front/Rear Torque Distribution
10
Power Limiter
88.2%
Downforce (Rear)
20
Ballast Weight
30 kg
Ballast Position
30%
ABS Level
0
Traction Control
0
Author
Ridox2JZGTE
Views
399
First release
Last update
Rating
4.00 star(s) 2 ratings

More resources from Ridox2JZGTE

Latest reviews

A hardcore GT3 driving experience. The car is stiff, but capable. You can drive hard, deep into corners without fear of losing grip. Sadly, the AWD can't be removed but it almost feels like a RWD car (just with a little more front bite!) This car will give you a workout, but it will also give you low lap times once you learn how she likes to be driven.
Ridox2JZGTE
Ridox2JZGTE
Thanks ALB123 :)
few tweeks & its fast ! 63 kg -50 47/53 weight & rear diff @ 15 20 15 . also my ride height is 95 95 .
Ridox2JZGTE
Ridox2JZGTE
Thanks for trying the tune and giving the rating :) Glad with a few tweaks the car suited to your needs and driving style, it's a replica but also a base tune :D
Back