B-Spec Endurance Bob issues

  • Thread starter Thread starter Buick McKane
  • 2 comments
  • 741 views
B

Buick McKane

Messages
2
Messages
Buick McKane
I am running the Sarthe 24 hour race in B-Spec. After a few pit stops, my drivers (levels in mid 30's) begin stopping every lap if I use any Pit Stop Strength settings. They change drivers every stop, and have no strength. I changed the setting to 0 and now they change when the car needs gas, but their strength does not return to any where near full. I've not had this issue before in other Enduro races.

What am I doing wrong?

Oh yeah, they are driving the new Red Bull car. I was thinking maybe because they pit so often they do not have time to recuperate fully.

Any ideas?

Also, I have pretty much had my PS3 on continuously for the last week or so running B-Spec Enduro races. Has this had any effect on the PS3's?
 
Buick McKane
Oh yeah, they are driving the new Red Bull car. I was thinking maybe because they pit so often they do not have time to recuperate fully.
Click to expand...

That's pretty much it. You would be better off running one driver...

Buick McKane
Also, I have pretty much had my PS3 on continuously for the last week or so running B-Spec Enduro races. Has this had any effect on the PS3's?
Click to expand...

It won't have any effect if you keep your PS3 properly ventilated and cool. (Not blocking the fans etc.)
 
Just switch Pit Strength to 0 (off). Then they drive until the tyres are done, or fuel finished. They sometimes make mistakes if they are pushed into the red. But with X2010, no problem. :)
 

Latest Posts

Back