Challenger Livery Editor Bug?

[Crawford1872]

Made a Butch Hartman livery on my charger to have something nice to look at with the engine swap bonanza being over.

Everything looks fine in the editor (pic a) but once exiting it looks like there are decals bleeding across multiple editing areas in a very random way (pic b)

Hard to fix due to it all being fine again in the editor itself. Have tried limiting the angle/depth of the decals to as low as I can without impacting the decal where I actually want it.

If anyone has seen a similar issue any help/feedback would be greatly appreciated.

Ps, this also happened on the other challenger I tried to make earlier today, so suspect it might be a single car issue.

Thank you.

 

[Crawford1872]

Was messing around with the custom parts and it appears spoiler A causes the decals to go all over the shop once you exit the livery editor.

A temporary fix but still not ideal.

 

[BloodRaven]

I just noticed something as well, with this car.

If you install the front spoiler and put decals on it, it won't show them on the passenger side once you exit Livery Editor. If you're in Livery Editor, it shows up just fine, but one you exit, it disappears. Everything else displays just fine.

This is the car in Livery Editor

This is the same car in Scapes Mode (it also displays this way in the garage or anywhere else)

 

[Bobby-Vegas]

The other day I noticed the front grill R/T badge and driver side hood/bonnet 426 Hemi badge are miscolored/bleeding. Found this weird and never noticed it before.

Sorry for going off topic, but this thread caught my attention to it.