- 36
- Scotland
Made a Butch Hartman livery on my charger to have something nice to look at with the engine swap bonanza being over.
Everything looks fine in the editor (pic a) but once exiting it looks like there are decals bleeding across multiple editing areas in a very random way (pic b)
Hard to fix due to it all being fine again in the editor itself. Have tried limiting the angle/depth of the decals to as low as I can without impacting the decal where I actually want it.
If anyone has seen a similar issue any help/feedback would be greatly appreciated.
Ps, this also happened on the other challenger I tried to make earlier today, so suspect it might be a single car issue.
Thank you.
Everything looks fine in the editor (pic a) but once exiting it looks like there are decals bleeding across multiple editing areas in a very random way (pic b)
Hard to fix due to it all being fine again in the editor itself. Have tried limiting the angle/depth of the decals to as low as I can without impacting the decal where I actually want it.
If anyone has seen a similar issue any help/feedback would be greatly appreciated.
Ps, this also happened on the other challenger I tried to make earlier today, so suspect it might be a single car issue.
Thank you.