- 449
- St. Kitts, West Indies
- GTP_Revoy
Hi all,
I have an old DFGT that was laying around in my room for a while due to a broken USB wire. I decided to reconnect the wires in hopes of getting them working; nothing too serious, just for the sake of tinkering.
So I cut both ends and connected both wires as seen in the picture below (it's not the prettiest, but like I said, it was a spontaneous decision just to see if I can get it working):
At first when I tried calibrating, everything worked (steering, buttons, pedals etc). But then I moved the wheel to begin taping and now the wheel isn't giving any input.
I tried everything including rewiring each wire. Nothing.
Is there any way to know short circuited a wire? Or is there some other way I can fix this?
I have an old DFGT that was laying around in my room for a while due to a broken USB wire. I decided to reconnect the wires in hopes of getting them working; nothing too serious, just for the sake of tinkering.
So I cut both ends and connected both wires as seen in the picture below (it's not the prettiest, but like I said, it was a spontaneous decision just to see if I can get it working):
At first when I tried calibrating, everything worked (steering, buttons, pedals etc). But then I moved the wheel to begin taping and now the wheel isn't giving any input.
I tried everything including rewiring each wire. Nothing.
Is there any way to know short circuited a wire? Or is there some other way I can fix this?