The best part about this table is that it's a one of a kind. yep that's right it's a three legged router table. It became three legged after I was trying to rout something one day and I noticed that the table was moving. That was from the plastic inserts working loose on the leg mounts. It was like routing wood on a waterbed. It was moving back and forth oh I'd say an inch and a half or so. Well after a few more pieces I'm in the middle of a cut and the leg just fell off. So I had to stop to keep from losing any fingers, and I tried to beat the inserts back in. Looked ok so I start making my cut again and would you believe it fell out again?!?! It's supported by a beer bottle to keep it from falling over while taking the picture.
How did you find that?
