F1 2013 T500 button mapping problem.F1 2010-2016 

  • Thread starter Thread starter eSZee
  • 6 comments
  • 886 views
eSZee

eSZee

Messages
11,342
United States
Chicago, iLL
Messages
GTP_Nismo
When in session menus, why does BUTTON 5 have two assigned functions? For example it will show button 2 blahblah, button 5 standings, button 6 blahblah, button 5 back? The problem is pressing button 5 takes me to standings and I can't back out to go to engineer or menu unless I have my keyboard and press ESC.
Is there a workaround for this? What am I missing?
 
I have the same issue on PS3. I have 2 look back buttons, even though I didn't even map that button. :odd:
 
axel edwards
change the functions in the custom controls menu
Click to expand...
I'll check again but there wasn't any way to change MENU BUTTON behavior when I was looking. You could change what each button did in race but nothing else.
I'll double check.
Thanks.

edit:
nope, as I said, can't change menu button behavior

Has no one else ran into this problem? It's pretty huge being in quali going to look at standings and then realizing you can't go back on track unless you have a keyboard.
 
Last edited:
It's been like that since 2011 when using a T500, no way to fix it. CM doesn't care either, I sent them a gazillion reports about it.
 
Mr. S
It's been like that since 2011 when using a T500, no way to fix it. CM doesn't care either, I sent them a gazillion reports about it.
Click to expand...
I see. Thanks for clearing that up.
 

Latest Posts

Back