Fanatec CSR dont save wheel tuning changes

[katpeeler]

After making tuning changes on my CSR Ill save by pressing the tuning button again. While Im racing it works fine but when I turn it off and return to play it goes back to the default settings. It will do this no matter what preset saves I use (!-5). I have never upgraded my firmware but I think its 706. How can I check??

 

[GTP_Plato]

Press and hold the A and B button followed by holding the two lower red buttons.

Your firmware should show, which by the sounds of it you still have 701, you will also be able to turn fan mode on or off.

 

[katpeeler]

Thank you..I have found out that I do indeed have 701 and when I get around to it Im going to update. By the sound of it the update is kinda tricky so I want to make sure I have plenty of time to do it.......Thanx again

 

[Patrick]

The update is quite easy and only takes a couple minutes.

 

[katpeeler]

The update is quite easy and only takes a couple minutes.

I know you

 

[Patrick]

Hehe I know.