Fanatec GT3RS V2 + CSP Pedals slight lose of acceleration

  • Thread starter Thread starter samuelleung83
  • 2 comments
  • 825 views
samuelleung83

samuelleung83

Messages
21
Australia
Hobart/Tasmania/Australia
Messages
its_tricky83
Last night while I was doing a 60 Lap A Spec race I noticed 10 laps in that although I had the accelerator flat to the floor, the on screen indicator was only at about 95% full. đź’ˇ
If I turn the wheel off and on again I immediately have 100% full acceleration. But then after another few laps it starts to lose acceleration again. :grumpy:
I'm wondering if any other CSP users out there are encountering this issue and if they have a solution?
As far as I know, I'm running the latest firmware for both the wheel and pedals.
Thanks in anticipation.
 
Sam, its

Marcus here, yes that has happened with fanatec CSP on mine, as well as many others, it could mean loose sensor or dirty, try go to control panel and press the pedal to see if its 100% all the time its fully pressed.
 
Thanks Marcus, (fancy you being the one to respond).
By control panel I take it you mean hook it up to the PC.

I'll give that a shot then. It seems to be about 15 - 20min before any noticable decrease in acceleration begins. That will be a very boring 20 minutes of my life. I'll have to sit a brick on the pedal or something. :-)

I've stripped back the accelerator and had a good inspection of the sensor. I can get it to go to 100% when the sensor isn't connected to the spring. ie. just the sensor flopping about on the pedal. I'm sure I'll suss it out but it's good to know someone else has had this issue.
 

Latest Posts

Back