fanatec

[imported_steve30b]

as anyone had both the h shifter and the sequentel shifter plugged into there wheel at the same time. i was thinking about modding the sequentel shifter into a hand brake so i would need both plugged in at the same time.

 

[cuco33]

Don't think you can plug both at the same time. I bought the shifter set and to be honest... I'm using the paddle shifters without clutch to shift. I don't like how Fanatec deisgned the bars as when it's on a wheel stand (and to a degree when mounted on a table) it moves too much for my tastes.

 

[VWMasteR]

This question came up this weekend amongst my friends. We landed on that we believe it is possible. We are going to use a splitter to see if it's possible.

 

[gslooney]

I don't think it will work..

The wiring of the shifters is very different, and this difference is also how the shifters are detected by the wheel.. so if you wire them in parallel via a splitter.. all sorts of nonsense might occur! (your not presenting to that port what fanatec designed it to receive!)

You'd be wasting your time and possibly the wheel!

 

[II-zOoLoGy-II]

Check over at GTPlanet.net I believe someone has done this mod if I am not mistaken. However, I believe it took some rewiring to make it work.

I will look for it and post it if I find it.

 

[Forcone]

Check over at GTPlanet.net I believe someone has done this mod if I am not mistaken. However, I believe it took some rewiring to make it work.

I will look for it and post it if I find it.

I think I watched a video of this on youtube. If I remember correctly, the shifter was wired to B button!

edit: it was possibly this: http://www.youtube.com/watch?v=KAiWEkYV5vI. Not very informative though.

 

[VWMasteR]

That would have been to make it in to a handbrake.