GT500 cars Tune & Logitech G25 Wheel

  • Thread starter Thread starter crasherkid
  • 3 comments
  • 1,149 views
C

crasherkid

Messages
43
United Kingdom
WEST YORKSHIRE
Messages
crasherkid_123
Hi,
Does anyone have any setup tunes for any of the GT500 cars like the Xanavi/Calsonics/Epson/Arta NSX etc etc.

I'm still adjusting to my G25 wheel and in particular the control of throttle.

Does anyone have a setup for any of these GT500 cars where they don't spin out as much regardless of how heavy you are on the throttle?
Please let me know, thanks in advance :)
 
Hi thanks for that, that's great I'll have a nose into that.

One more thing:

I tend to use Grand Valley Speedway as my "Test Track" as I know this inside-out.

With the GT500 cars, if I'm coming out of a corner, even a touch of gas will send my car flying.
I did a little experiment with the Honda Epson NSX (somewhere under 649 PP) as this car would spin out the easiest, more than any other car.

I went into weight ballast settings and basically put most of the weight towards the back of the car. This seemed to do the trick as the car no longer span out even if I stepped on the gas pedal half way around a corner.
The negative effect of this was that lap times were taking alomst 2 seconds longer. I don't mind the slightly slower laptimes if it means I can play with the car how I prefer.

Question is, with 4WD cars, how would it be best to adjust the weight settings on these??
 
Don't use ballast.
Weight at the rear... theoretically... should make the car oversteer more, not less.
GVS is a great track to test on, for certain conditions, use any of the tunes from the sticky and you should be fine.
 

Latest Posts

Back