My DYI Project

  • Thread starter Thread starter MeM
  • 7 comments
  • 409 views
M

MeM

Messages
389
Alright, Im going to do a DIY project with my steering wheel, Right now I have the essencials for making a DIY project. IMcluding a little seat. Not a car seat though. Ive used the search button a ton of times. im trying to find the cheapest DIY with all wood and nails. Im probably making out plans within the next hour or so and building it with my neighbor today or tomorrow, I still want to do research first. Im not to handy with things so hopefully It will work. Im 6'3"
 
if you rip apart your steering wheel you can find the incoming signal that sets off the vibtation mechanism, tap this voltage and design a dc current amplifier, get a couple of low voltage-high current motors and attatch these via actuators to your seat...when playing GT3 and you hit a wall your whole seat will vibrate...its easy to add a vibration control you set it anywhere from gentle to earthquake level...

i can give you dc current amplifier circuits...you build them on vero board.

hows that for a diy project?
 
Sounds fun, that will be my next one :) Right now Im focusing on making like a little racing cockpit. Like a couple 2 x 4's to put my seat in and my steering wheel on and the pedals.. I have to table around and i have to use a crappy lap attachment which is horrible.
 
Heres pic of my chair Its not the best chair. But It will work
Picture_171.GIF


Any Ideas?
 
and ideas?...yes throw that away, go down your local breakers yard and get an old car seat fro next to nothing and start there...

are you serios with that chair?... remember some races in GT3 are 2 hours or so long....your arse will be be like a blood orange after an enduro in that seat..
 
any help, Like what are the different ways i could build it with wood around the chair? Or like into the char? or?
 

Latest Posts

Back