I would like to get my CST Pedals (made by Todd) to plug into my 911 Turbo S wheel. (PWTS)
I have a broken Clubsport (v1) set that I can cannibalize for parts.
Here is what I am thinking, although I am a complete electronic newbie.:
I would just need to wire the CST pots/cell to the Clubsport board while manipulating the CST signal's range to the Clubsport range, correct?
For example; If the CST pots operate at 5-7.5v while Clubsports operate at 2.3-5V, I could just use resistors to lower the voltage, correct?
As for the load cell, I am oblivious. Would it work the same way?
I have a broken Clubsport (v1) set that I can cannibalize for parts.
Here is what I am thinking, although I am a complete electronic newbie.:
I would just need to wire the CST pots/cell to the Clubsport board while manipulating the CST signal's range to the Clubsport range, correct?
For example; If the CST pots operate at 5-7.5v while Clubsports operate at 2.3-5V, I could just use resistors to lower the voltage, correct?
As for the load cell, I am oblivious. Would it work the same way?
