PVC Cockpit UNDER $100

[Crispy]

Hello everyone. I was wondering if there was a way to make a cockpit out of PVC that will hold a Fanatec GT3 RS, that doesn't have an annoying pole between the seat and the pedals, and will hold up reverse mounted Clubsport Pedals. I would also like it to have an area to hold the 6-Speed shifter and a place to put a handbrake. The shifter must be about where it is on a real car. If anyone knows how to do this, or knows of a guide on how to do this, while remaining under $100, please post about it. That way I can know, and many others can too if they want.

P.S. I'm not too worried about how it looks, as long as it has the material needed to preform, I'm fine.

 

[ClassicMini]

With PVC rigs the bigger cost should be the chair, the tubes and joining pieces shouldn't cost much (where I live a joining piece costs about a dollar). Completely guessing, I'll say without a chair it's very hard to exceed the $100 mark. As you can guess, you can find chairs from $50 to $500. To keep costs down, buy a car seat from a junkyard, wash it and fit it a car seat cover.