T500 RS installed in a Playseat Race Pro Alcantara

  • Thread starter Thread starter ferid
  • 15 comments
  • 12,323 views
Paddles or Peddles? If it is for the peddles then only a minor mod needs to be done. Offset the holes and add large washers on the outer edges.
 
works just fine if you use the two center holes on the pedals.

t7fuz9.jpg
 
Ouch, that pedal plate is STEEP! They desperately need to make the pedal plate adjustable.
 
No it can't be bent unless you made a cut in the metal and were able to weld it when finished. It's not just flat, there are side braces. The side plates are for assed strength.
 
ah...well where there's a will there's a way...i'll figure something out when i get my T500 next week...don't know how i feel about cutting and welding anything but i just might!!!! MUA-HAHA
 
it may look steep in the picture because of the angle the pic was taken and my ultrawide lense. I had the G25 before and the angle is the same and Perfect. I tried it without the pedal plate before with just the t500 pedals flat on the floor or in reversed position. Trust me, you definitely want it mounted to the sloped pedal plate.

and yes someone finally noticed, i removed the ugly bracket that is unused in F1 mode. it's easy to remove if you pull out the clips. The playseat doesn't wobble at all with the T500, if you dig in the main t500 thread I posted a short gameplay video with my setup.
 
Overdoser
it may look steep in the picture because of the angle the pic was taken and my ultrawide lense. I had the G25 before and the angle is the same and Perfect. I tried it without the pedal plate before with just the t500 pedals flat on the floor or in reversed position. Trust me, you definitely want it mounted to the sloped pedal plate.

and yes someone finally noticed, i removed the ugly bracket that is unused in F1 mode. it's easy to remove if you pull out the clips. The playseat doesn't wobble at all with the T500, if you dig in the main t500 thread I posted a short gameplay video with my setup.
Click to expand...
I have the same setup and the pedals are at a perfect 90deg angle. Works really great and all is very stable. 👍

Which clips do I need to pull out to remove the back bracket, do you have a picture?
 
Denur
I have the same setup and the pedals are at a perfect 90deg angle. Works really great and all is very stable. 👍

Which clips do I need to pull out to remove the back bracket, do you have a picture?
Click to expand...


This one:
dnbjuu.jpg
 
This is my final setup. I didn't remove the back bracket entirely, but only its side supports and flipped it below the pedal rest (since I'm out of tie-raps, I used a piece of string to hold it up).

t500rs1.jpg


t500rs2.jpg
 

Latest Posts

Back