Can't use this FGT in A-Spec

  • Thread starter Thread starter Blitz24
  • 8 comments
  • 688 views

Blitz24

Chromalusion Member
Premium
Messages
21,801
United States
NJ/USA
Messages
Blitzbay
I'm trying to run the Formula Championship in A-Spec but the car feels broken to me. Whenever I go into a tight corner, the rear of the car breaks traction and the car spins around like a top. The ABS is on so its not that issue and the car feels jukey.
 
Perhaps it needs rigidity restoration in GT Auto? What's the mileage? Is your downforce maxed, that's the only tuning I needed.
 
Perhaps it needs rigidity restoration in GT Auto? What's the mileage? Is your downforce maxed, that's the only tuning I needed.
I restored the engine but the car hasn't gotten a rigidity restore. I guess I need to save up another 250 k for that then. Grinding here I go.
 
I restored the engine but the car hasn't gotten a rigidity restore. I guess I need to save up another 250 k for that then. Grinding here I go.
I suppose your level is high enough to do the Indy at extreme events, 98k per 5 min?
 
I just kepted some throttle applied (10-20%) while trail-in braking, it keeps the rear in check.
 
Its high enough of a level of course 25/25.

I don't like hitting the brakes out of the corner and its hard to do when battling for position because the AI is bump happy.

Its weird though, using stock set-up, my bob ran 3 whole championship series plus GVS 300 KM twice in that car with no issues.
 
The FGT has very strong engine braking.

I found increasing the Diff's inital torque helped a lot.
Also, with MT trans, leave the car in a higher gear through tight corners to reduce the revs(weakens engine braking effect)

And whatever you do, avoid coasting at all costs, its like using the handbrake.
 
I had to turn skid recovery on and ASM. I feel pathetic doing this but its the only way to keep the car from skidding.
 
Last edited:
Back