Need exact size of threads and shaft on Fanatec SQ

[Mayaman]

I am having different length shafts made for the Fanatec shifter SQ. I need exact shaft size and the thread it uses.

thanks

 

[mrbasher]

The thread is M12x1.5

Sorry, not sure on the length. I don't own one and don't plan to

However, I don't believe it works like the TH8RS where a different shaft can be used. I think the shaft goes all the way through. I could be wrong on that though. Many adapter exist for 12mm though.

 

[Mayaman]

Thanks bud, these shafts wont be replacements, they are additions, to make the stock shaft longer.

I would have asked you, but Iknow you are busy with your baby.

 

[mrbasher]

no prob at all. If you want to extend it, you might be able to get a coupling nut in the right size. Then I'd use a jam nut on each side to secure it well. Look up coupling nut and you'll see what I mean. McMaster doesn't seem to have 12x1.5 unfortunately... :/ I can check locally if you'd like. We have a huge screw/bolt place nearby and I have a rather large order to pick up soon...

You can also call McMaster and explain what you are looking for. They are absolutely amazing. Bar none.

 

[Mayaman]

no prob at all. If you want to extend it, you might be able to get a coupling nut in the right size. Then I'd use a jam nut on each side to secure it well. Look up coupling nut and you'll see what I mean. McMaster doesn't seem to have 12x1.5 unfortunately... :/ I can check locally if you'd like. We have a huge screw/bolt place nearby and I have a rather large order to pick up soon...

You can also call McMaster and explain what you are looking for. They are absolutely amazing. Bar none.

that would be great thanks!