There hasn't been an update in a while. Since it's bright out, why not now?
Here's what I'm doing about that exhaust. I'm cutting off the stock one; muffler and all. I'm going the lazy route and literally gluing in a cylindrical shaft somewhere on the base.
Somewhere. Didn't want to spend the money on a metal tube, so I'm using scrap goodies I have lying around; a dowel! I've carefully drilled into the one end to give some impression of a tube. I will be wrapping it in bare-metal foil to get the impression of a metal tube, and will be colouring the inside a matte black so you can't tell it's fake.
Remember how I said I was just going to glue it onto the base somewhere? Well, there wasn't a good surface, so I just made one. It will be coloured appropriately to avoid sticking out like a sore thumb.
Letting that sit for like another month, I finally said there's probably nothing left to be done, so I've went and laid down the primer to see where I need to correct some surfaces just now:
Here are some notable surfaces I will be working on next:
Needs filler.
Smooth out that panel between the skirt and door.
Will be considering if I can get rid of the second parting line, which ever one is not deliberate, as well as that gunk above the diffuser "blade".
After all these years the putty job I did to correct the arches wasn't good.
I knew about the straight lines, but it didn't occur to me how deep of a crack it was.