obutto 1 monitor stand

[TheEagle]

Hi
I observed obutto seat has one monitor stand which comes along with the seat:
http://www.obutto.com/ozone_simracing.html

I wonder how to attach a monitor to this Built-in stand.Does it have holes or we need to drill ?

 

[Publicsafety]

Has holes, it is ready to go. And a great rig I may add.

 

[TheEagle]

Has holes, it is ready to go. And a great rig I may add.

You mean it only needs a monitor?
If that is true can you give me an example of a monitor?

 

[Publicsafety]

Any monitor with a Vesa mount. I use Asus 24" 1080p 120hz monitors.

 

[TheEagle]

Any monitor with a Vesa mount. I use Asus 24" 1080p 120hz monitors.

I see most of LCD monitors have a table base like this one:
http://www.amazon.com/dp/B00681RILY/?tag=gtplanet-20

Should we remove it?
After we remove it do we need to buy a VESA mount or the obutto seat built-in monitor stand is enough?

 

[sesselpupser]

VESA is a mounting standard, it specifies the spacing and diameter of the holes on the mount. The Obutto conforms to the VESA standard and is such a VESA mount and therefore all you need is the Obutto mount and a monitor with VESA holes (check the manufacturer specification, they usually mention whether or not it is VESA compatible, if not some googling should turn up useful results). You just have to remove the desk stand and bolt the monitor to the mount with four (probably) M4 bolts, every single VESA mount I've seen has come with bolts and washers so you probably just need a screwdriver.

Edit: I just checked, the E2420L uses 75x75mm VESA which the Obutto supports.

 

[TheEagle]

VESA is a mounting standard, it specifies the spacing and diameter of the holes on the mount. The Obutto conforms to the VESA standard and is such a VESA mount and therefore all you need is the Obutto mount and a monitor with VESA holes (check the manufacturer specification, they usually mention whether or not it is VESA compatible, if not some googling should turn up useful results). You just have to remove the desk stand and bolt the monitor to the mount with four (probably) M4 bolts, every single VESA mount I've seen has come with bolts and washers so you probably just need a screwdriver.

Edit: I just checked, the E2420L uses 75x75mm VESA which the Obutto supports.

Thank you very much every thing is clear to me now