@ClaudioWRC74 @Fanapryde do you (or anybody else) know how I get those three dots beneath "Transparent" to appear? I'm running CM on two different PCs and I haven't got this option in the Custom Showroom on either of them. Dev mode is active. I'd love to try something with that option in another Mod
"Another mod" might be the issue. There are mods that for some reason (beyond my knowledge) don't trigger these dots.@ClaudioWRC74 @Fanapryde do you (or anybody else) know how I get those three dots beneath "Transparent" to appear? I'm running CM on two different PCs and I haven't got this option in the Custom Showroom on either of them. Dev mode is active. I'd love to try something with that option in another Mod
just tried it with a few different mods as well as with an original Kunos car, they never appear. Also downloaded the "997 GT3 Cup" @ClaudioWRC74 posted in his initial post, no dots:
don't worry, after looking through the settings for the fifth time I finally found the "update to non-tested versions" option, ticked it, and after a short update the dots are there, looks like that was the reason... as much as I love CM & CSP, all those settings tend to confuse me every time^^
Hi Mass@DaWallace @Pfalzdriver has this Procar (in all its various guises) always been limited to 6,500 rpm?
It seems very low so I did a little digging.
"As for that glorious, 277bhp straight six? Well, they increased the gloriousness, obviously, getting 470 horsepower from the 3.5-litre unit at a heady 9,000rpm."
Ogle this one-off road-legal BMW M1 Procar
If this doesn’t make you pine for an M1, turn in your petrolhead card nowwww.topgear.com
I might be wrong but I don't think it's always been like this on the AC Procar. Has somebody, somewhere, at some time, limited the revs to try and match real-world performance figures or something? If so, the shackles really need removing and a 9,000 limit reinstated.
[ignore - see below. Revs seem correct, the dials need updating]
Edit: Mmmm... in data/engine.ini, LIMITER=9200
Is it just that revs aren't calibrated correctly on the tacho?
Didn't you change the dials in one update and maybe didn't recalibrate the needles?
Edit 2: seems like the tacho needs updating with new legends:
View attachment 1206204
Here's ours:
View attachment 1206205
6,500rpm on ours has the needle at 12 o'clock, which corresponds with around 9,000rpm on the photo of the actual instruments above.
I've not got a much earlier version of the car so can't check what the original dials showed.
Edit 3: Here's a different photo of a real dash. Slightly different dial arrangement, but the revs display up to 9,500.
View attachment 1206206
TLDR: our tacho needs updating with a corrected rev scale.
I was using different type of glass texture, including kunos one so i don't think this is the problem.Usually, when I have this problem, I act like this:
1) I check the type of mesh and its normal, in order to understand from which side it is visible. For each glass I create a duplicate, so as to have one visible from the outside and one from the inside;
2) Regardless, if the glass is still completely transparent, I recreate the texture from scratch.
It happened to me recently with a dekon monza. The windshield was there but the texture made it completely transparent. Changed that, I solved the problem
Racedepartment downloads have been painfully slow for me, for a long time.
Things like this always make me think that the modder must drive using chase cam, which then subsequently lowers my expectations about the physics.
I already have the right Stack Gauge. New update will come soon and i will add an optional extension config folder, wich could be used to replace the current extension config folder, for those who have problems with the refraction. 🙂
Do you use CSP?
Good shout - many thanks. That now enables the glass to be selected and toggled.
wauw , this is better then some v1.0 ...F1 2011 Mod release by me and @StoffelWaffle
The previous F1 2011 mod was a 2011 2012 frankeinstein with 2011 body and 2012 tyres, rear wing, rim and steering wheel. So we decided to do it properly by converting the whole 2011 squad using only 2011 parts. It also has animated drs and suspension.
You can now drive the renault with its original steering wheel and no broken nose ^^
Please be aware that this is a V0.1 so it's not perfect yet. Since i have a potato computer and the 2011 mod wasn't my main focus I'll have to rely on feedback to fix the cars especially on the graphic side.
credit to bastien for the soundmod : https://www.racedepartment.com/downloads/f1-2011-blown-diffuser-sound-mod-pack.54384/
Download link in descr of this 
